GenerLink is installed outside your home at the electric meter in less than 30 minutes by a utility technician. And, in most cases, you do not need to be at home for the GenerLink installation.

Who installs a GenerLink?

GenerLink is installed outside your home at the electric meter in less than 30 minutes by a utility technician. And, in most cases, you do not need to be at home for the GenerLink installation.

Can I install a GenerLink in Ontario?

While Generlink is not yet approved in all areas of Canada, this is changing. The unit gets installed underneath your electrical meter, offering a port on its bottom edge to accept a special cable. This cable connects the generator to the Generlink, creating a system that’s more than just safe; it’s also smart.

Can I install a GenerLink myself?

Installation of GenerLink™ must only be performed by properly trained technicians. Do not proceed with this installation unless you have been authorized by your local electric utility to do so.

How much does an electrician charge to install a generator transfer switch?

Average Generator Transfer Switch Installation Cost For residential applications, an electrician will spend three to four hours to install the transfer switch for which they would charge from about $200 to $500. However, the overall generator transfer switch installation cost includes both materials and labor.

What is better interlock or transfer switch?

Compared to a transfer switch, which is limited to a particular number of circuits, an interlock kit allows you to run power from a generator to any circuit within the electrical panel. While this is good in theory, there’s a risk of overloading the generator if it’s not sized according to the load.

Does GenerLink make 50 amp transfer switch?

L14-50 Straight: Delivers up to 50 amps of power to your home.

Does Dominion Energy install GenerLink?

The agreement gives Dominion Virginia Power the ability to offer GenerLink, Pepco Technologies’ patented interconnection device, to the nearly 1.8 million residential customers it serves in the state of Virginia. … Dominion Virginia Power will arrange for the installation of the GenerLink units.

What states allow GenerLink?

Some known states where GenerLink is legal: Ohio, Kentucky, Tennessee, Indiana, Georgia, Maine, Illinois, Idaho, Alabama, New Hampshire, Michigan, Montana, Wyoming, Vermont, Massachusetts, Wisconsin, New Mexico, Arizona, Utah, Nevada, and Florida.

How do I use GenerLink?

With GenerLink, using your portable generator is easy and safe. Turn off appliances on your breaker panel, plug your generator into GenerLink, start your generator and turn on your appliances from your breaker panel.

Article first time published on

Are GenerLink legal in Canada?

GenerLink has been available for years across much of Canada, with the exception of B.C. and Quebec. … According to Stewart, GenerLink systems must be installed by a licensed electrician and inspected by the power utility.

Is GenerLink UL listed?

The GenerLink is a UL-listed, socket-mounted transfer switch that provides a safe and convenient way to connect portable generator power to your home in minutes!

Is GenerLink legal in Alberta?

Unlabelled product, however, is not permitted for installation in Alberta. Please be advised that ESAFE will no longer evaluate or label Global Power Product’s Generlink line of Meter mounted transfer switches or similar devices.

Do I need an electrician to install a transfer switch?

You’ll have time to get familiar with the generator, stock up on gasoline, and most important, hire an electrician to install a transfer switch—a small device that allows you to power entire circuits in your house with a portable generator—without the hassle and potential dangers of using extension cords.

Do you have to turn off your main breaker when using a generator?

You typically will need to turn the circuit breaker off and turn the fuel valve on before starting it up. Give the machine a few minutes to warm up, then flip the circuit breaker on. Use long, heavy-duty extension cords made for outdoor use to connect appliances to the generator one by one so as not to overload it.

Can I plug my generator into my dryer outlet?

ABSOLUTELY NOT!! This is NEVER an option. You MUST use some form of transfer switch or interlock, along with the proper male inlet. Also, a male-to-male cord is called a “suicide cord” for a reason.

Can you test GenerLink with power on?

Problem- Testing The GenerLink will not transfer to the generator during testing with utility power present.

How does a GenerLink transfer switch work?

When the Power is out from the Utility Lines the GenerLink automatically transfers from the Utility lines to the GenerLink, when the generator is running. When the power comes back on it will not switch back to the utility lines until the generator runs out of gas or is turned off.

Should I get a 30 or 50 amp transfer switch?

It’s typical to use a 30-amp breaker for generators up to 8,000 watts and a 50-amp breaker with 8,500- to 15,000-watt generators. … That’s easy enough to do by switching off breakers that control non-essential appliances and circuits, and switching on circuits that you may need at any given time.

Are interlock kits safe?

Why choose an interlock kit? When an interlock switch is properly installed, it prevents the generator circuit breaker and the main circuit breaker from both being on at the same time. An interlock kit is a safe and cost-effective way to ensure you’re using a portable generator safely.

What size breaker do I need for a generator?

The circuit breaker you need is compatible with your service panel brand. It’s normal to use a 30-amp breaker for generators up to 8,000 watt and a 50-amp breaker for 8,500 to 15,000 watt generators.

Why do you need a circuit breaker interlock?

The function of the racking mechanism interlock is to prevent the breaker from moving from the connection position before the breaker is in the open position. … Racking interlocks prevent a circuit breaker from being connected to energized bus in the closed position.

Is GenerLink approved in Virginia?

The agreement gives Dominion Virginia Power the ability to offer GenerLinkâ„¢, Pepco Technologies’ patented interconnection device, to the nearly 1.8 million residential customers it serves in the state of Virginia. … Dominion Virginia Power will arrange for the installation of the GenerLinkâ„¢ units.

Does Pepco allow GenerLink?

Pepco Offers New Device for Connecting Portable Generators to Homes. … GenerLink™ is a collar-shaped device that Pepco technicians can install behind a homeowner` s electric meter in about 30 minutes. During a power outage, the homeowner simply plugs a generator into GenerLink`s™ interconnection port.

Is GenerLink approved in Nova Scotia?

Its website states: “Listed below are the provinces that have approved the GenerLink … NS, NFLD, PEI, ON, MAN, ALB, SK, YK. … “This is a product that is available to people in Nova Scotia,” said McLeod. “They can either buy them online or get them through their local electrical supplier.

How do you hook up a portable generator to a house without a transfer?

1. Step 1: Create a Place for the Outlet Utility Box.
2. Step 2: Drill a Hole for Running Your Generator Cables to the Outlet.
3. Step 3: Install the Waterproof Box Outside Your Wall.
4. Step 4: Connect the Wire Into the Outlet.
5. Step 5: Connect Generator to Outlet and Test it.

Is GenerLink approved in Connecticut?

We are authorized GenerLink installers in Connecticut.

What is a Genlink?

GenerLink™ is an interconnection device that enables you to connect your portable generator directly to your home’s wiring system. During a power outage, your generator becomes your source of emergency back-up power. GenerLink™ is designed as an alternative to expensive transfer switches and hazardous extension cords.

Does Duke Energy install generators?

The renewable net metering program creates opportunity for Duke Energy Carolinas (DEC) customers to install renewable energy generators at their homes or businesses.

How many watts do I need to power my house?

How many watts does it take to power basic items in an average size house? In a typical home, essential items will average 5000 – 7500 watts of power to run.

Is a transfer switch worth it?

The biggest benefit of having a transfer switch in a residential setting is that you gain the ability to power things up via your circuit breaker panel instead of having to use extension cords. This includes hardwired devices, such as your dishwasher, hot water heater, air conditioning, and ceiling fans.